Set them back to their default values as explained below: Parameters should not normally be changed. Having difficulties communicating with a particular controller. Not change this value from the default value of zero unless you are VCDS is going to wait for the module to respond to a given message. If it does not, you can always increase it again (to a maximum of 99).ĬAN Timeout defines how much longer than normal Protocols. The default value should work for all applications, but Measuring Blocks on control modules that use the KWP-2000 Decreasing it increases the sample rate in KP2 Time only applies to controllers using the KWP-2000 protocol. That this may cause unreliable communications with some controllers. Possible in the Measuring Blocks screen, set this to 0. This is called Char Int and the default value is 1 when used with a legacy interface. Timing. This is called Char Int 2K and the default value is 6 when used with a HEX-NET or HEX-V2. Note, however, that this may cause unreliable communications withĬhar lnt 2K / Char Int also affects the protocol To get the highest sample rate possibleĢ5. There should be no reason to set Debug to anything other than zero unless you are instructed to do so byĬurrent default value is 55. This should decrease VCDS's susceptibility to interference by things like virus scanners (except A zero in this field (the default) means NO debug output will be Contact us for advice ifĬontrols how much debugging information VCDS records. Value from the default unless you are having difficultiesĬommunicating with a particular controller.
The default unless you are having difficulties communicating withĪ particular controller.
RAN ONLINE AUTO POTS DELAY CONFIG PC
Used during the initialization of a session between the PC and theĬar. KW2 Delay has to do with the amount of time With our current Interfaces, this field is unavailable.
This means VCDS will determine the correct That VCDS will try when connecting to a controller. Which is used for updating the firmware in the interface, registration, WiFi configuration and other functions. On the HEX-NET or HEX-V2 the button is used to launch the VCDS Interface Config utility Testing a port's outputs for troubleshooting certain The LED on the Interface to blink and may be useful for Legacy Dongle Interfaces, t he button causes Then you should test the port in the car using Of the results show "Short to Ground" or "Short to +12V"
0 kommentar(er)
